Garage Door Spring Repair in

Your garage door repair in is just around the corner.  But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis.  Cleaning your garage door more or  track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.

For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.

Safety first for common garage door reapair issues

Garage Door Fix

A problematic garage door can cause a host of problems — from water leaks to security concerns. Here are a few of the most common garage door-related problems and some inexpensive ways to fix them.



Problem: Your garage door won’t open or close.
Solution: First, check the electronic keypad. Keys become stuck or damaged due to moisture, age and use. If your keypad doesn’t work, use your remote garage door opener to open or close the door. If the door works with your remote opener, your keypad is broken. If neither the keypad nor the remote opener works, it’s likely that the motor receiver (or the motor itself) is broken. A licensed pro will diagnose the problem and recommend a solution.

Problem: Your garage door jams when opening or closing.
Solution: If your garage door stops while opening or closing, you may have a mechanical issue. Start by lubricating the rollers — the small wheels that fit into the track — with WD40. Next, clear any blockage or rust from the track and look for off-track rollers. If you notice a broken roller, call a licensed pro to reset your garage door.

Problem: Your garage door leaks during storms.
Solution: If your garage is wet after after a storm, it’s usually the sign of a faulty door seal. To stop leaks, simply replace your older seal with a newer model. Make sure your replacement is the correct size (always measure the width of your garage door before making a purchase).

If leaks continue, call a professional. Constant garage leaks can damage other parts of your home.
Problem: Your garage door slides down (or up) by itself.
Solution: A garage door that won’t stay open or closed is most likely suffering from faulty extension springs. If your door slides down, your springs are too weak or worn. Likewise, if your garage door slides up, your springs are too strong. The correct spring tension is related to the height and weight of your garage door. If you’re unsure about which springs to choose, have a pro help you match the right springs to your door.
In go with the best for garage door repair

Top reasons why you need garage door repair. This is part of a continuing series.
7. The garage door limit settings isn't set properly
Often you’ll notice that your garage door torsion spring won't allow the door to close. It immediately goes back up instead of staying in the closed position. This issue usually arises with brand new garage doors that were just installed or older models that may need to be reset. If this happens, the most likely culprit is the open and close limit settings of your garage door opener.

This limit range tells the garage door opener how far the door should move before it’s fully closed. If your settings are too high, the door will hit the ground before the opener thinks it should and assume the door is hitting something in its path. It will then automatically reverse to prevent crushing whatever is beneath it.

There are knobs or dials located somewhere on your garage door motor that you can use to adjust the limit settings. The exact location and resetting procedures will vary depending on the brand and model of garage door you have. Your owner’s manual should have more specific information on how to adjust your limits. You may need to experiment with a few adjustments before finally getting the correct setting. If you find that adjusting the limit settings isn’t working, it might be time to call a technician to come and help get your garage door to stay closed. Emergency Garage Door Repair

Denver

Replace Garage Door Spring in

Your garage door repair in is just around the corner.  But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis.  Cleaning your garage door more or  track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.

For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.

Garage door safety is everyone's concern

Overhead Door Repair

Top reasons why you need garage door repair. This is part of a continuing series.
2. Your Photo Eye Is out of Alignment
You may remember a time as a kid when you and your siblings would close the garage door and run underneath it as fast as possible to make it out before the door closed. Well, on any garage door installed after 1993, that’s no longer possible thanks to two tiny photo eyes on either side of the garage entrance. These photo eyes transmit an invisible beam between each other that detects if anything is in the garage door’s path when it closes. This safety measure is there to prevent automatic garage doors from closing on top of someone or something and causing serious injury or damage to property.

If you notice that the garage door opens normally but doesn’t make any attempt to close when the remote is pressed, the first thing you’ll want to do is visually inspect the photo eyes. Over time, these eyes can get dirty, causing the light from the beam to be blocked. They also can eventually become misaligned, causing the eyes to not match up on both sides.

When cleaning the photo eye, you should take care not to scratch or damage the eye since it’s made of glass, similar to that of a camera lens. The photo eye itself is pretty small, only a few centimeters in diameter, but it can get dirty rather easily. To clean it, you’ll need a soft cloth and a mild, streak-free cleaner. Gently wipe away any dirt or residue that has built up on the eye and be careful not to over saturate as excessive wetness can cause dirt to stick to the eye more quickly.

If your photo eyes are clean and the door still isn’t closing, the next thing you’ll need to do is check the alignment of the eyes. The eyes should be pointing in exactly the same direction and at the same angle. If they’re off, they won’t register that the other one is there, and it’ll assume something is in its path, causing the door to stay in the open position. When checking the alignment, measure the height of each photo eye from the ground. Use a level to make sure they’re pointing directly across at each other at the same angle. A laser level will make this part a little easier, but if you don’t have one, a regular level will work as well.

Once you have the eyes cleaned and aligned, test your door to make sure it opens and closes normally. If you’re still experiencing issues with the photo eyes, it may be time to call the professionals to come out and diagnose the problem.



In go with the best for garage door repair

Operating Your Door While Power Is Out
Pull the rope back and as close to the garage door opener motor as possible. This will keep the rope out of the way while you operate the door in manual mode. Hopefully your power is out for only a short period of time, and you’ll soon return to automatic operation of your garage door opener.

If not, don’t worry. Homeowners used garage doors manually for years before automatic openers became widely available. It’s more effort and certainly less convenient, but a power outage shouldn’t prevent you from using your garage however you like.

What To Do When Power Returns
When the power comes on, you’ll need to reattach your garage door to the automatic opener. Pull down on the handle at the end of the rope again, just as you did when you first disengaged the opener. Then pull up on the door until you hear or feel it snap back into place once more. Alternatively, you can also push the button on your automatic opener. You’ll see the spring attachment reconnect once the opener reaches a certain point — and you’ll be back in business again.

If for any reason your garage door fails to engage again with the automatic opener after a power outage, you may need to call a provider of garage door repairs. It’s always possible that the return of power has led to a power surge that’s made the automatic opener inoperable. Garage Door Fix

Denver