Overhead Door Repair in Fort Lupton

Your garage door repair in Fort Lupton is just around the corner.  But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis.  Cleaning your garage door more or  track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.

For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.

Safety first with overhead door repair

Overhead Door Repair

Top reasons why you need garage door repair. This is part of a continuing series.
7. The garage door limit settings isn't set properly
Often you’ll notice that your garage door torsion spring won't allow the door to close. It immediately goes back up instead of staying in the closed position. This issue usually arises with brand new garage doors that were just installed or older models that may need to be reset. If this happens, the most likely culprit is the open and close limit settings of your garage door opener.

This limit range tells the garage door opener how far the door should move before it’s fully closed. If your settings are too high, the door will hit the ground before the opener thinks it should and assume the door is hitting something in its path. It will then automatically reverse to prevent crushing whatever is beneath it.

There are knobs or dials located somewhere on your garage door motor that you can use to adjust the limit settings. The exact location and resetting procedures will vary depending on the brand and model of garage door you have. Your owner’s manual should have more specific information on how to adjust your limits. You may need to experiment with a few adjustments before finally getting the correct setting. If you find that adjusting the limit settings isn’t working, it might be time to call a technician to come and help get your garage door to stay closed.
In Fort Lupton go with the best for garage door repair

Why change your remote
Garage door openers are fairly simple mechanisms that tend to last a long time. Even if yours is still working fine, there are good reasons to consider replacing it. Newer models offer increased safety, security and convenience.

Here are some of the primary reasons why you might want to buy a new garage door opener.
Safety Reversal


Since 1993 garage door openers have been required to be equipped with a safety reversing mechanism.

This feature utilizes two sensors about six inches above floor level on both sides of the door. When any object, such as a child or pet, runs through the light beam created by these sensors while the door is closing, the door immediately stops and reverses.

If your garage door opener does not have a safety reversing feature, or if the one it does have no longer works, replacing the opener is highly recommended.
Noise Control

Does your garage door opener wake people up or otherwise disrupt the household because it makes so much noise? If so, a new opener will almost certainly be quieter.

The original style of garage door opener opened and closed with a chain drive. If you can see something that looks like a bicycle chain near the motor unit of your opener, consider replacing it with a screw drive or belt drive garage door opener. Even a newer model chain drive unit will likely be quieter than an older model Garage Door Repair

Denver