Your garage door repair in Evergreen is just around the corner. But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis. Cleaning your garage door more or track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.
For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.
Unusual problems with garage door repair requiring same day service
Top reasons why you need garage door repair. This is part of a continuing series.
8. The disconnect switch was enabled
If you can hear your garage door motor running for what seems like the full amount of time it normally would take to open or close the door, but the door doesn’t move, chances are the disconnect switch has been enabled. Every garage door opener comes with a disconnect switch in case you lose power. This allows you to open or close the door manually so your car isn’t stuck in the garage until the power comes back on.
This switch is usually attached to a rope that can be pulled or a knob that can be turned to disconnect. Sometimes, this switch can accidentally come unhooked causing the door to be disconnected from the motor.
However, if you lose power and use the disconnect switch, you’ll need to reattach it to use your garage door motor to open and close your door again. Open the door all the way and then reattach this hook. Then try opening or closing the door again with your transmitter, and you should be all set. It will be easiest to reattach this hook when your car is not in the garage, as you’ll need to place a step ladder underneath the motor to reach it.
In Evergreen go with the best for garage door repair
We all come to depend on our automatic garage door openers. They deliver wonderful convenience for our busy lives — but we often tend to take them for granted.
When something like a power outage renders your garage door useless, it suddenly becomes a huge inconvenience. How are you supposed to get your car inside the garage — or get it out? Do you need to call a company that offers garage door repairs?
Fortunately, the answer to that question is no. Opening your garage door during a power outage is simple once you know how to do it. Here’s a look at getting into your garage when your garage door opener is rendered unusable due to a power outage.
Start with the Bypass
Your garage door is most likely equipped with a function that turns off the automatic opener and allows you to use the door manually. Have you noticed a rope hanging down from your garage door opener system — probably a rope with a handle connected to the end? That’s your bypass trigger.
When you yank down on this handle, the opener disengages from the automatic system that’s become unusable by the power outage. It’s a good idea to pull down on the handle and activate your bypass only when the garage door is closed. If you choose to do so while the door is open, the weight of the door could cause it to slam shut at a violent speed — which could damage the door or be dangerous to objects, animals or people standing nearby.