Install Garage Door Opener in Genesee

Your garage door repair in Genesee is just around the corner.  But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis.  Cleaning your garage door more or  track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.

For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.

Unusual problems with garage door repair requiring same day service

Garage Door Opener Installation

Top reasons why you need garage door repair. This is part of a continuing series.
2. Your Photo Eye Is out of Alignment
You may remember a time as a kid when you and your siblings would close the garage door and run underneath it as fast as possible to make it out before the door closed. Well, on any garage door installed after 1993, that’s no longer possible thanks to two tiny photo eyes on either side of the garage entrance. These photo eyes transmit an invisible beam between each other that detects if anything is in the garage door’s path when it closes. This safety measure is there to prevent automatic garage doors from closing on top of someone or something and causing serious injury or damage to property.

If you notice that the garage door opens normally but doesn’t make any attempt to close when the remote is pressed, the first thing you’ll want to do is visually inspect the photo eyes. Over time, these eyes can get dirty, causing the light from the beam to be blocked. They also can eventually become misaligned, causing the eyes to not match up on both sides.

When cleaning the photo eye, you should take care not to scratch or damage the eye since it’s made of glass, similar to that of a camera lens. The photo eye itself is pretty small, only a few centimeters in diameter, but it can get dirty rather easily. To clean it, you’ll need a soft cloth and a mild, streak-free cleaner. Gently wipe away any dirt or residue that has built up on the eye and be careful not to over saturate as excessive wetness can cause dirt to stick to the eye more quickly.

If your photo eyes are clean and the door still isn’t closing, the next thing you’ll need to do is check the alignment of the eyes. The eyes should be pointing in exactly the same direction and at the same angle. If they’re off, they won’t register that the other one is there, and it’ll assume something is in its path, causing the door to stay in the open position. When checking the alignment, measure the height of each photo eye from the ground. Use a level to make sure they’re pointing directly across at each other at the same angle. A laser level will make this part a little easier, but if you don’t have one, a regular level will work as well.

Once you have the eyes cleaned and aligned, test your door to make sure it opens and closes normally. If you’re still experiencing issues with the photo eyes, it may be time to call the professionals to come out and diagnose the problem.



In Genesee go with the best for garage door repair

Things to know about garage springs
If you are like most people, you probably have paid very little attention to your garage door springs. While understandable, this oversight is also a bit unfair. There's really no single part on your garage door and garage door opener that is more important to the raising and lowering of the door. That's one reason for paying some respect to the springs. Here's another: Garage door springs are dangerous!

Very dangerous, in fact. Do yourself a favor and read Garage Door Safety Tips before thinking about repairs or replacements.

If you are having trouble with your garage door, it may be due to some problem with the springs. (For more information on diagnosing garage door problems, see Garage Door Troubleshooting.) Garage door springs do break, and they can be replaced. There are suppliers out there who sell replacement springs to DIYers, and there are DIYers who have safely and successfully replaced their own springs. I won't try to convince you not to take that approach if you need new springs, but I will strongly suggest that you carefully weigh the risks versus the rewards in this project before deciding to do so. And I also suggest that you make sure your health insurance premium is paid up.

This article is not a how-to on garage door spring replacement. It is intended to acquaint you with garage door springs and some of the maintenance duties you can perform yourself.

Two Types of Garage Door Springs
There are two different types of springs used on garage doors. Torsion springs are attached just above the closed garage door, while extension springs are located above the upper tracks on both sides.

Garage Door Springs and Your Safety
Garage door springs are tightly wound, meaning they are under a lot of tension.

When they break, or when some unsuspecting DIYer tries to fiddle with them, they can cause a whole lot of pain. Wise DIYers know that this is one household chore that is best left to the pros. (For tips on finding a qualified garage door pro, see How To Find the Best Garage Door Installers and Repairmen). If your garage door is old, or if it is showing signs of age, let an experienced contractor inspect your garage door springs.

But if the springs are just squeaking and otherwise making a lot of noise, there are some things you might want to do before calling in the troops. A little squeak does not necessarily mean a big problem, any more than an aching head means a brain tumor. Apply some garage door lubricant to the springs and see if it makes any difference. If it doesn't, you may have a serious problem brewing. For suggestions on the best lubricants to use on your garage door, check this site. For some additional advice on reducing the noise of your garage door, see How To Quiet a Noisy Garage Door.

Garage Door Safety Cables
The two types of garage door springs discussed above work differently. A garage door with extension springs will have a safety cable on each side of the door running through the spring and attached to the wall or ceiling.

These cables are an important safety feature. Extension springs are under a great deal of tension, and if one was to break, it could cause serious injury. Safety cables help control a broken spring.



If you have extension springs on your garage door but can't find any safety cables, call a garage door pro and get a pair installed.

Out of Balance Springs
The best sign of a well-functioning garage door is that it opens and closes smoothly and quietly. When it stops working as it should, the problem can be serious. Try operating the garage door manually (pull the cord attached to the arm connecting the rail trolley system to the door). If the door continues to be difficult to operate, the problem could be that the springs are out of balance. In this case, you can be confident that the problem isn't going to fix itself.

And failing to fix it could result in an escalating list of worn and broken parts. Call a pro ASAP.

Garage Door Spring Brackets
Garage door springs are attached to brackets on the bottom of the garage door. As with the springs, these brackets are also under a lot of tension and should only be adjusted or otherwise maintained by a pro. Newer models of garage doors have tamper resistant brackets that prevent the curious but inexperienced among us from getting into trouble. Garage Door Spring Repair Cost

Denver