Install Garage Door Opener in Castle Pines

Your garage door repair in Castle Pines is just around the corner.  But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis.  Cleaning your garage door more or  track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.

For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.

Unusual problems with garage door repair requiring same day service

Same Day Garage Door Repair

Top reasons why you need garage door repair. This is part of a continuing series.
8. The disconnect switch was enabled
If you can hear your garage door motor running for what seems like the full amount of time it normally would take to open or close the door, but the door doesn’t move, chances are the disconnect switch has been enabled. Every garage door opener comes with a disconnect switch in case you lose power. This allows you to open or close the door manually so your car isn’t stuck in the garage until the power comes back on.

garage doors
This switch is usually attached to a rope that can be pulled or a knob that can be turned to disconnect. Sometimes, this switch can accidentally come unhooked causing the door to be disconnected from the motor.

However, if you lose power and use the disconnect switch, you’ll need to reattach it to use your garage door motor to open and close your door again. Open the door all the way and then reattach this hook. Then try opening or closing the door again with your transmitter, and you should be all set. It will be easiest to reattach this hook when your car is not in the garage, as you’ll need to place a step ladder underneath the motor to reach it.
In Castle Pines go with the best for garage door repair

Security
Older garage door openers were vulnerable to thieves. Because their remote controls functioned with a fixed code, someone with a special device could sit outside your house and find the code, allowing them to open the garage door.

New garage door openers have a “rolling code” feature, which changes the code every time the unit is used.

Bad guys can no longer duplicate the code and get into your garage uninvited.

No Keys
Older garage door openers did not offer keypads that could be mounted outside the garage. This handy feature allows you to enter a code into the keypad that will open the garage door. No keys required.

You may be able to buy a keypad to install with your existing garage door opener. If not, though, this might be a good reason to upgrade. Newer keypad units even eliminate the need to remember a code. They operate by touch, using fingerprint detection to open the door.

Battery Backup
One of the big inconveniences of a power outage is often the inability to operate the garage door opener. Garage door openers are now available with battery backup systems that will kick in automatically when you lose electrical power. Overhead Garage Door Springs

Denver